Search results

  1. skevac

    MAJOR HELP needed. Transfer case issues

    The tech swapped the switch from another truck when they worked on it last time. No dice! I would like them to replace every sensor, switch, controller that has to do with the 4wd system. But when you're dealing with warranty gotta jump through their hoops. I Guarantee doing that would be way...
  2. skevac

    MAJOR HELP needed. Transfer case issues

    Actually started acting up after they had to pull the whole dash out twice to put a blend door motor in for the heater. Could be coincidence? Who knows? All I know is that I'm pretty frustrated at this point! It really acts like a loose/bad connection somewhere? It comes on and goes off...
  3. skevac

    MAJOR HELP needed. Transfer case issues

    Truck is in my signature. Been to the dealership 3 times now for the same issue. Without trying to use 4wd the 4X4 light in the dash starts blinking. Most times it's at start up of the truck. The when it's doing this sometimes you can switch the 4x4 knob and it goes into 4wd and other times it...
  4. skevac

    NEED HELP Transfer case shifting issues

    Probably should have put this in the tech section. Sorry. I'll still take any help! Mods move if need be?
  5. skevac

    NEED HELP Transfer case shifting issues

    Truck is in my signature. Been to the dealership 3 times now for the same issue. Without trying to use 4wd the 4X4 light in the dash starts blinking. Most times it's at start up of the truck. The when it's doing this sometimes you can switch the 4x4 knob and it goes into 4wd and other times it...
  6. skevac

    Cheapest place to buy OEM fuel filters

    Found them on the initial site I bought them on. Had to type in the part # to get them to come up for some reason. $32.28 each Thanks for the replies.
  7. skevac

    Cheapest place to buy OEM fuel filters

    Where is the cheapest place to buy the Motorcraft or Racor fuel filters? I purchased them from diesel-filters.com before but they don't have either one listed anymore. Just some off brand ones. Paid around $30 dollars last time from there. Used to be a decent deal at the Navistar dealer but just...
  8. skevac

    Aftermarket wheel help

    I just went out and measured the tread width of the tires I'm going to be running. They measured 10.75". So if I am figuring this right the 1/2" offset of the wheel and the difference between the 9" width of the wheel and the 10.75" tread width (1.75") divide that in half (7/8") because half of...
  9. skevac

    Aftermarket wheel help

    I probably also need to factor in the section width of the tire? Which is 13". So is it safe to say with the offset and section width it's going to stick out 2.5 inches? Looking at running a 325/60/20.
  10. skevac

    Aftermarket wheel help

    So, like 1/2" farther than the factory wheel or 1/2" past the fender at the top?
  11. skevac

    Aftermarket wheel help

    I'm looking at a set of 20x9 -12 offset wheels. On a 2010 without flares how far are these going to stick out of the fenderwell. Don't want them to stick out past the fender a mile as I don't want sh!t thrown all down the side of my truck every time I drive through a small puddle. I know this...
  12. skevac

    Transfer case acting goofy help needed ASAP

    It was showing a code for the transfer case shift motor. The motor was bad and replaced but it didn't fix the problem. The dash had been out of it a few months earlier to replace heater parts and they found a pin in an electrical connection near the steering column that wasn't getting a good...
  13. skevac

    My Build Thread-American Hogger

    Ryan is the "Hogger" tearing up the sand or what?
  14. skevac

    Transmission help needed ASAP

    Went out and started it today and the 4X4 light is still blinking and it drove in forward and reverse just fine. Definitely the transfer case. Does the transfer case have it's own controller? What could be causing the light to flash while not even trying to shift it into 4wd? The whole dash was...
  15. skevac

    Transfer case acting goofy help needed ASAP

    I posted in the aftermarket section with no responses yet so I'll try here. Truck is in my signature. Running Gearhead tunes on a Mini maxx. Don't drag race, truck pull, or beat the piss out of it. The 4x4 light in the dash is blinking either 4 low or 4 high. I haven't touched the 4 wheel...
  16. skevac

    Transmission help needed ASAP

    A little update. Went to drive it home the 4x4 light was out. I decided to try and put it in 4 wheel drive turned the knob at approx. 15 MPH and it made quite a bang and I'm pretty sure went into 4 low. Stopped put it back into 2wd and drove it home 5 miles. Transmission was shifting fine and...
  17. skevac

    Transmission help needed ASAP

    Truck is in my signature. Running Gearhead tunes on a Mini maxx. Don't drag race, truck pull, or beat the piss out of it. The 4x4 light in the dash is blinking either 4 low or 4 high. I haven't touched the 4 wheel drive switch for a couple of months and the light just started blinking after I...
  18. skevac

    Fram cs96667a fuel filters

    Anyone using these fuel filters? They look to have the wrap over the filter like the OEM ones? I know everyone says Motorcraft or Racor but I've ran across a good deal on the Fram. Not looking for problems just looking to save a little $$$$.
  19. skevac

    Wire question

    2010 on the rear of the truck near the trailer wiring harness there is a single wire not in the loom that is capped off, yellow with a green stripe. Wondering what this is for?
  20. skevac

    Turbo rebuild question. Help needed ASAP.

    If I order a rebuild kit for my factory turbo can I just rebuild it my self or does it need to be rebalanced? Not changing a thing just putting in new seals and bushings. The guy that is selling me the kit says it doesn't need to be rebalanced because I'm putting the same parts back in it. Need...

Latest posts

Members online

Top