Search results

  1. 20170502_2123511

    20170502_2123511

  2. 20170502_2123511

    20170502_2123511

  3. 6.7 Powerstroker

    Streetmax X and 2015 HPFP

    Morgan sent me a stock dlted 2015 race tune and it idled fine. So it is in the tuning. He said if it did work fine then he'd take that file and revise the rest of the tunes for the streetmax x. So hopefully he's going to have it done tomorrow. Here's a quick video. And the vacuum line is capped...
  4. 6.7 Powerstroker

    Streetmax X and 2015 HPFP

    It's capped still from the non vgt. Runs fine in the non vgt tune.
  5. 6.7 Powerstroker

    Streetmax X and 2015 HPFP

    I have and Austin and him say it's not the tunes. I made videos of Forscan with the non vgt tunes that idled fine and another that shows the erratic idling. I wasn't sure what to monitor so I monitored what I thought may help and hopefully they can see these and realize they need to adjust them...
  6. 6.7 Powerstroker

    Streetmax X and 2015 HPFP

    I went ahead and tuned it back to my non vgt race tune and the truck idles fine. I drove it and no stumbling or cutting off when I stopped and it drove fine. A bit smokey but not bad considering I changed turbos and fuel pumps. It even spooled pretty good. What would I need to have changed in...
  7. 6.7 Powerstroker

    Streetmax X and 2015 HPFP

    I came across this on another forum. http://www.powerstroke.org/forum/6-7-performance-parts-discussion-2011-2016/254023-issues-begin.html Exact same issue I'm having except these guys have an H&S tuner and I have a SCT. The recommended fix is to run the factory air box which I'll gice it a try...
  8. 6.7 Powerstroker

    Streetmax X and 2015 HPFP

    Today or gradually started doing the stumbling idle like it was in the tow tune and this afternoon it finally threw the same code p228f. That fuel regulator/sensor is new so that can't be it. Anyone have this issue after installing a new turbo or fuel pump and have a solution?
  9. 6.7 Powerstroker

    2015 turbo torque specs

    Install the 2 new pedestal-to-turbocharger bolts and washers and tighten in 2 stages. Stage 1: Tighten to 10 Nm (89 lb-in). Stage 2: Tighten an additional 180 degrees.
  10. 6.7 Powerstroker

    Hot side intercooler pipe

    I am looking for an aftermarket hot side pipe that does not leak. I hooked up my air compressor to where my air filter is and found a significant leak at the turbo connection of the factory hot side pipe. Is it normal for a leak or should it be air tight? Any recommendations for a quality piece...
  11. 6.7 Powerstroker

    BD Scorpion Turbo

    How loud is the fass fuel pump? I have one and I have yet to get it to quiet down.
  12. 6.7 Powerstroker

    Streetmax X and 2015 HPFP

    So the tow tune works but in the race tune it won't even idle right. It just stumbles the whole time and you can actually hear a fuel knock or something so I immediately put it back into the tow tune and it's running fine.
  13. 6.7 Powerstroker

    Streetmax X and 2015 HPFP

    Who'd you get your tunes from originally and who's tuning fixed the issue? Because this morning I stuck it in Street tune and it started doing this which is very similar to what it was doing before except it hasnt cut off yet its just got a stumbling idle when I stop. It was working fine in tow...
  14. 6.7 Powerstroker

    Streetmax X and 2015 HPFP

    Okay so I finally got everything straightened out. I replaced the fuel pressure control valve on the back of the drivers side rail and it stopped cutting off. I also took off the intake, top up pipe, down pipe and got to the clamp on the lower up pipe and it was clamped a little crooked so it...
  15. 6.7 Powerstroker

    2015 turbo torque specs

    Do you have a pic of the oil filter? I just installed a turbo with the internal oil supply and I didn't get this filter part or see where it would go. Turbo to block is 41 lb-ft in sequence; drivers side front of truck 1st, passenger side rear 2nd, passenger side front 3rd, drivers side rear...
  16. 6.7 Powerstroker

    Streetmax X and 2015 HPFP

    I talked with Morgan and he says it's not the tuning. The truck did throw code p228f which is the fuel pressure control valve on the left rear fuel rail. After searching online I found 2 other posts where the guys had the same exact same issues with the truck stalling and replaced the sensor and...
  17. 6.7 Powerstroker

    Streetmax X and 2015 HPFP

    I drove it all day in the tow tune and this afternoon it started to cut off when I'd come to a stop. This is a video of it in the driveway when I got home. Has anyone experienced this? It did throw a p2073 code once when it cut off the first time this afternoon but never did again. My map...
  18. 6.7 Powerstroker

    Driveline vibration

    Up to 3/4" axle plunge is normal. Just the rear end moving.
  19. 6.7 Powerstroker

    Oil leak

    You'll need a Lisle 22930 3/8" Low Profile Disconnect to release the fitting. With out it it can be a pita.
  20. 6.7 Powerstroker

    Streetmax X and 2015 HPFP

    I re-tuned the truck by redoing the load first tune then the tow tune and it runs better. RPMs don't fluctuate when I stop like it's cutting off but the spooling is still lacking right now. It makes a weird noise before spooling up like it's hissing. I also noticed some soot on the passenger...

Latest posts

Members online

Top