Search results
-
Wide track front axle
Is the axle housing on the wide track axle longer? Has anyone swapped out the regular dually axle to a wide track one? Thanks Billy T. [email protected] -
GPR - Stancor, White Rodgers, Emerson...any better than the OEM one
Is the Stancor, White Rodgers, Emerson relay really better than the OEM one? I had to swap out my third relay today. The original Stancor relay last 90k miles. The Stancor relay was replaced with a White Rodgers relay and that one lasted 60K miles. Now the relay is called an Emerson one...- gnxtc2
- Thread
- Replies: 11
- Forum: 7.3 Aftermarket
-
Differences between OBS and SD 7.3s?
On the block, by the oil filter housing. This should keep you occupied for a while: https://www.forddoctorsdts.com/coffeetablebooks.html/ Billy T. [email protected] -
Differences between OBS and SD 7.3s?
The cranks beginning with engine serial# 201681 do not use a wear sleeve on the rear seal. Billy T. [email protected] -
HI idel Mod
I made a bracket that utilizes the screws that hold the ALDL connector. Billy T. [email protected] -
Much help needed on Finding Transfer case bolts!
Common metric fasteners are 8.8 or 10.9. Which ones did you get? Billy T. [email protected]- gnxtc2
- Post #10
- Forum: 94-97 Tech
-
Best place to buy Coolant filter kit
I use the Motorcraft green stuff with distilled water. I have the Int'l water pump and use the filter that is pre-charged with SCA. So no need for the DCA. Billy T. [email protected]- gnxtc2
- Post #7
- Forum: 7.3 Aftermarket
-
Best place to buy Coolant filter kit
What about installing the International water pump with the integral filter? Billy T. [email protected]- gnxtc2
- Post #5
- Forum: 7.3 Aftermarket
-
Much help needed on Finding Transfer case bolts!
https://www.mcmaster.com/98093a636 Billy T. [email protected]- gnxtc2
- Post #7
- Forum: 94-97 Tech
-
Hydroboost Conversion Done
Yes, no longer can one get Motorcraft part# BRMC67. Aftermarket ones are still available. Billy T. [email protected]- gnxtc2
- Post #230
- Forum: 94-97 Aftermarket
-
Hydroboost Conversion Done
Thanks...wouldn't think going from a 1.250 to 1.3125 bore would make much of a difference. The Motorcraft OBS master has been discontinued. Billy T. [email protected]- gnxtc2
- Post #228
- Forum: 94-97 Aftermarket
-
Hydroboost Conversion Done
I'm gonna re-open this thread..... As you know, I've done the hydroboost conversion. I'm just not too happy with the brake pedal feel. The pedal feels harder than I would like it to be. Don't get me wrong, the truck does stop without issue. I drove a 1994 C/C F-SD truck with the same...- gnxtc2
- Post #225
- Forum: 94-97 Aftermarket
-
Fuel pump setup
I have 175/80s and use a stock SD pump. No pressure drop. No noise either. Be careful with Walbro pumps. There are a lot of fake re-branded and bootleg Walbro pumps out there. Also, there are a lot of bootleg Bosch pumps out there. Whatever fuel pump you decide to go with, make sure it's...- gnxtc2
- Post #31
- Forum: 7.3 Aftermarket
-
Guys that have done SD springs with rsk on front.
On the OBS trucks, the shackle is in the front and the rear mount is fixed. The Reverse Shackle Kits, hence the name move the shackle to the rear. Now, the center pin on the OBS leaf packs are not centered. Couple the off center pin with the shackle up front, gave the OBS trucks a rougher...- gnxtc2
- Post #18
- Forum: 94-97 Tech
-
Guys that have done SD springs with rsk on front.
Looks like either cut it or space it out 1/4" https://www.skysoffroaddesign.com/collections/ford-78-91-front-suspension/products/ford-fsrsdal-004 Billy T. [email protected]- gnxtc2
- Post #16
- Forum: 94-97 Tech
-
Guys that have done SD springs with rsk on front.
Here is my SKY kit. It was done back when the RSK with SD springs were getting popular. Also, had SKY lower the cross bar to clear the IC. The IC in the truck is an all aluminum 7.3 IC. Billy T. [email protected]- gnxtc2
- Post #14
- Forum: 94-97 Tech
-
RYD Motorsports SD axle swap kit
https://www.rydmotorsports.com/ Billy T. [email protected]- gnxtc2
- Post #4
- Forum: 94-97 Aftermarket
-
how fast should lube oil pressure rise? - lpop concerns after turbo failure
But the oil drains from the line when the motor is shut off . Billy T. [email protected] -
Guys that have done SD springs with rsk on front.
I don't think the Velvet Shackles are made any more. In order to swap in rear SD Springs: - Drill out front spring hanger - Either trim one of the leafs and enlarge the spring bolt on the OBS spring shackle or use the SD shackle and grind it down to fit the frame hanger. or Get the rear SKY...- gnxtc2
- Post #8
- Forum: 94-97 Tech
-
how fast should lube oil pressure rise? - lpop concerns after turbo failure
Shop air is really not a good test to test that gauge....air vs liquid. Air travels a whole lot quicker than fluid. Jake (lincolnlocker) has a hatred towards Rotella. At this point, I would send in an oil sample. Also, I would try an electrical type gauge. I use the AutoMeter Ford Factory...
