Search results

Ended up going with a set of 33x12.5x20 toyo mts, going to run those on my stock 08 20s till spring time.

Similar to this, this is with 33x12.5

I'd like it stick out some, not too much maybe like an inch or two out past the fender

So the time has come for new tires, figured I'd do wheels at the same time. Problem is figuring out the whole offset and back spacing, I wanna run 20x10 and either 33x12.5 or 35x12.50 on my 02 f250 4x4 with a leveling kit. Google wasn't much help so if anyone happens to have either setups on...

Ill let him know, thanks crowz

7.3psd97444 is having issues getting on and isn't sure why his IP address was banned.

Mainly need the two plugs that go into the controller and about 3' of the wires. Dont need the full harness as its going into an 02.

Ok after doing some intense googling LOL I'm seeing that apparently the 02s have a similar fuse box like the 05-07s. on the 02s the relay in the box is marked for trailer battery and on the 05-07s its the upfitter switches.

Was easy to swap the pieces in, jut have to figure out where to tap the harness into to get power.

New piece is a different color than the tan trim on the 02s. Not a huge difference but it's noticeable

Hmmm I was just thinking of figuring out which wire did what on the harness coming off the aftermarket controller and then which wire was what on the factory harness and go from there. I need to figure out where to get power for the switches as well since I have the oem harness with relays.

Sorry for the delay, all thats left is running wiring it and to get the small glovebox to close a little better.

Bump

Installed 05-07 upfitter switches, brake controller and lower trim piece into my 02 f250

If I can get it to work just like a normal brake controller I'd be happy with that.

Alright so today I swapped in an 05-07 lower dash with upfitter switches and brake controller. Now has anyone used the oem brake controller in a pre 05 truck? What did you do to get it to work? Wit the upfitter switches where did you tie into to get power? I have the complete harness with relays.

Drove it to and from work..... thought about washing it but I might do that after I install the levelling kit

Sometimes my truck looks good.