Purchased a 2003 CCSB 6.0 200K miles with a 6" inch lift on 37/13.50R22's. When I test drove the vehicle the truck had a horrible vibration. Jacked the front end up ball joints were shot. So I did ball joints, tie rod ends, and hubs on both sides. Test drove it and realized I was dealing with a driveline vibration. Posting this tonight before I start tomorrow but first I will try to drop the carrier bearing down in the morning. If that doesn't solve the issue my next step would be to consider a 1 piece drive shaft. Anybody have any suggestions or experience dealing with the same issue? I hear it is a pretty common problem. Also going to go with a set of traction bars if anyone can recommend those too. Thanks everybody in advance.
Side note: I didn't get the vehicle aligned yet either but I am positive the vibration is worse than an alignment problem.
Side note: I didn't get the vehicle aligned yet either but I am positive the vibration is worse than an alignment problem.