1994.5

[1994point5]

So today I went out started my truck and lit it run for a minute then before I could put it in gear it shut off. The check engine light flashed a couple of times then stayed on. I cycled the key and the light flashed again no wait to start light or anything. The truck would crank but wouldn't fire won't smoke. So from what I read on other posts I figured the CPS was bad so I went out and replaced that only for the same thing to happen. I changed tunes and it fired again and died shortly after. Any advice or tips would be greatly appricated

 

[elrodalexander73]

Get a scan tool and find out what you have as far check engine light my friend..

 

[1994point5]

I pulled the ts out and it starts and just I just have a miss now

 

[Justin@DP-Tuner]

I pulled the ts out and it starts and just I just have a miss now

Sounds like there is an issue with the chip.

Has your 94.5 been flashed to an OBDII compliant code yet? If not, we can do it for you. This will enable you to connect an OBDII scan tool to the truck and monitor some PID's, as well as read/clear codes.

 

[1994point5]

It's hasnt but I'm very intrested

 

[Justin@DP-Tuner]

It's hasnt but I'm very intrested

Just order a Stock tune flash from HERE and send us your PCM. We will flash it to a later code/calibration so your OBDII port becomes active and useful.

Diagnostics will be so much easier for you.