F350stroker
New member
- Joined
- Mar 20, 2015
- Messages
- 37
- Reaction score
- 0
I have my engine on a stand because I am swapping it into a gasser truck. I checked the injector ohm readings at the plugs to see what they were reading and I get 3.5 across the board. I have read that under 5 is good, I want to do the bitterroot rebuild and 160cc pistons while the engine is out and hope that those readings would mean that the injectors seem consistent. They have 225,000 km on them. On the fence to diy or buy a set of stage 1s. Anyone go the diy route ?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk