6.4L HP Turbo Components

[buckster]

Inside the high pressure turbo, there are three bolts that thread directly into the center section. They seem to be what the VGT ring slides on. Can anyone advise where I can source new ones?

 

[Powerstroke Cowboy]

If there is markings on the bolts you could always go to a hardware/fastner store and get them matched up.

Or just pick up some stainless bolts that match.

 

[Racer71]

I think the heads are fairly low profile

 

[Powerstroke Cowboy]

I think the heads are fairly low profile

They look like it in the picture. A good fastner store should have what's needed.

If not, grind or belt sand the heads down to match.

Another way would be to check with a sponsor on here. Like KC Turbos. They might have something as well.