All guys with a Gear Vender Overdrive

Corb@CorbinShipping

New member
Joined
Sep 3, 2011
Messages
3,063
Reaction score
0
Location
Autryville, NC
Quick question....

how much do you have to shorten the drive shaft when using one?

I have a cclb DRW, and a ccsb SRW. Both 2010s. I am going to run an OD unit on the cclb DRW. Can I take the unit off of the ccsb SRW and use it on the cclb DRW with the Gear Venders? Or is there a specific length that needs to be achieved? I am going to replace the shaft on the ccsb with a CV jointed two piece shaft, and I would hate to waste the one that comes off, as it is in good order. And, would also hate to pay more money to shorten the cclb DRW setup, if I can use the leftovers of my azz hauler.

I don't know if anyone has done this, and came up empty on a search. Thanks for any input,
corb
 

Shootingstar

Member
Joined
Jul 11, 2011
Messages
204
Reaction score
0
Location
NE OK
Give mike at Haller's a shout


Sent from my iPhone using Tapatalk with fat fingers so excuse the typos!
 

Latest posts

Members online

Top