Electrical Gurus my throttle doesnt work

Tonyowens · Nov 3, 2016

My ole girl caught on fire recently. Ive completely rebuilt it. It starts and runs fine, starts right up but my throttle doesnt work. I have access to schematics but im making no progress. The harness in the engine bay is from a 95 and the one in the cab is from a 97. Ive heard the pins are different on them. Any insight on how to rig up the throttle wiring would be greatly appreciated. Cheers

79jasper · Nov 4, 2016

Pretty sure you need to repin the harness connectors at the firewall.

Sent from my SAMSUNG-SM-G935A using Tapatalk

Tonyowens · Nov 5, 2016

Do you know exactly what pins?

79jasper · Nov 5, 2016

No.
You'll have to compare the two connectors from diagrams.
If you do a hard search, I think it's been talked about.

Sent from my SAMSUNG-SM-G935A using Tapatalk

Tonyowens · Nov 6, 2016

Im having trouble finding a diagram for a 97. Ive found a few for 95 though

TyCorr · Nov 6, 2016

Bust out the multimeter and see what you're lacking. Move pins accordingly. Or take the assembly out and get the correct one.

Tonyowens · Nov 6, 2016

How can i ohm them out if its on each side of the firewall and the connector would have to be plugged in?

m j · Nov 6, 2016

I can provide the 97 diagram from the EVTM.
gimme a sec to see if I can find the book before honey starts yelling, as I am supposed to be going out the door...

Tonyowens · Nov 6, 2016

Awesome.

m j · Nov 6, 2016

the idle validation will cause a no pedal.

m j · Nov 6, 2016

need any other page lemme know I will add it to the photobucket.
I am out the shouting began

Tonyowens · Nov 6, 2016

Thanks brother hopefully this will lead me in the right direction

Tonyowens · Nov 6, 2016

And im sorry to hear about the shouting. But helping out a fellow stroker is worth it haha

Tonyowens · Nov 6, 2016

That shows them where they go in accordance to the computer . does it show the pinout going through the firewall. Where the 2 harnesses meet together?