Injectir electric connector repair - how to

[Rob D]

Hey guys posted this question in my build thread but hoping it will get answered faster as it's own thread. Snapped an injector connector from the rocker box when I pulled my manifold tonight. Was told you can swap out the plastic connector from another injector. Who knows how to do this? Pic of what I am talking about below. Any help much appreciated - maybe it's easy and self explanatory but I have not taken the valve cover off yet to investigate. Apologies if that's the case.

 

[Rob D]

Any Mods who read this would appreciate it if you corrected my spelling error in the title so when/if this is answered it may help others search successfully in the future - thx

 

[Gary]

You need a small pick tool, remove that orange square lock key inside the pins,
then there is a lock tab on each pin that you have to release so each pin will side out. Then it all just snaps back together. Before you start draw a diagram of the location of each wire in the connector.

 

[Rob D]

Do you need to remove the oil rail to do this Gary or can you get enough slack without?

 

[DZL JIM]

If you look in the end of connector, the pins are numbered 1,2,3,4. Mark down what color wire goes to what number, it's the easiest way to keep track.