Installing a BD Dielse Blow Off Valve

[strokin6L]

ok fellas, here we are shes all done installed, and just about tuned up, i have to put some shims on the spring and make a few more tweeks but this thing is awesome!, Not only that but it works and solved my barking issue! Il have some videos of this thing up this week!

Good to hear Mark...we all love vids.

 

[powerstrokedkid87]

heres a little update.....After the Dyno video...and the Horsepower number...were still looking for more at the rear wheel....in the works now to push us over the edge...Steed Speed manifolds...divided up pipes.....and a FICM tune.....still some final tweeking of the BOV is needed, and some new coating on the up pipes...which will get done shortly....all and all truck is just about where i would like it to be...then looks like it will be time to attack the pinch weld covers...and center console shifter....so much for keeping the truck together...and being where i finally want it to be

 

[FX4 F2-Fifty]

staying t3? sounds like a sweet setup!

 

[07_powerstroke]

What's your plan for the pinch welds?

 

[powerstrokedkid87]

staying t3? sounds like a sweet setup!

Not realizing how close the shows that we are going to this year are, were going to hold off on the manifolds and up pipes for now, were going to go to a
t4 a the divided up pipes this should get some serious air flow to the motor. Am in the works now at getting the FICM squared away, and hope to finalize that from PHP this week. The new manifolds and up pipes will be added to the winter project list, i beleive we may end up pulling the cab again to attack some cosmetic ideas...but that will be for another thread at a later time!

What's your plan for the pinch welds?

We are making some pinch weld covers, actually cut them yesterday to fit, not just need to weld on the studs for attachment, then prep and paint. Should be welded this week, and hopefully plan to paint them when i get the tail gate done for a nice paint match.