Corb@CorbinShipping
New member
My trans was in Aaron's truck at dpc![]()
Sorry... Since DPC... LOL
My trans was in Aaron's truck at dpc![]()
With my truck, my SCT sometimes does not load the correct TCM tune with the preloaded IDP files. You should be able to notice though when you load xrace and race lock, that when your trans is shifting like a stock truck, something isnt right. Sometimes takes my TCM 2-3 times to accept the correct TCM tune.
With my truck, my SCT sometimes does not load the correct TCM tune with the preloaded IDP files. You should be able to notice though when you load xrace and race lock, that when your trans is shifting like a stock truck, something isnt right. Sometimes takes my TCM 2-3 times to accept the correct TCM tune.
With my truck, my SCT sometimes does not load the correct TCM tune with the preloaded IDP files. You should be able to notice though when you load xrace and race lock, that when your trans is shifting like a stock truck, something isnt right. Sometimes takes my TCM 2-3 times to accept the correct TCM tune.
When You notice the sct didnt load the right tune, does it say the right one is loaded on the screen, or does it show that the tune you loaded is the wrong one?? Does that make any sense, if not ill try to think up a way to re-word what I'm trying to ask..LOL LOL
Woah
Mine does this also. when switching files, I always re select what I want and no issues. Did extreme street/race lock to race/stock to stock/race to race/race one day/ morning. That was a pain. Just wanted race/race.
I doubt you'll find it's in the tune. We've been running these trans tunes since the trucks were released. All of the 3.03 trans tunes are the same, with the exception of the new early lock program. That's the trans program most run daily, although the others work just fine.
Forsure - changing acouple things up.
A lot of that is in my thoughts as well. However, the trans was not my original trans. It was a built trans from Aaron. And my factory trans worked great, with stock internals, and stock fluid for 130,000 miles, over 80 k tuned.Just asking here...
In my mind, if you were cruising along day after day and everything was tip top, perfect, perfect, perfect then all of a sudden at full power it went BAMMM!!! And sh*t was internally broken, I would think ehhhh, mayyyybe a bit much on the line or something in the tune.
If on the other hand it's scorching the fluid, I'd have to ask.... what did those shifts FEEL like??? Like, were the shifts always firm and quick no doubt.... or were the shifts, or at least one or a couple soft and spongy? Trans fluid doesn't just look like crap for no reason. It usually involves a long time with soft, sh*tty shifts.
How did the shifts FEEL?
If everything felt good, and shifted good, and the fluid is burned up, then you may have some sort of valving issue leaking fluid creating heat, or something in the pump, or regulation valves, or something stupid like a piston holding force against a clutch pack when that pack is supposed to be released, burning it up.
I would ohm out my trans harness reaaaaal well to make sure you don't have something stupid happening that's causing the trans to try and activate more than one gear at a time or something.
I'm just a guy reading a post.... but what you describe, if there were no soggy shifts beforehand... seems like a chaffed wire, or hydraulic circuit/mechanical failure causing fluid pressure to bleed off, or something to activate when it shouldn't, or dragging clutch packs with a stuck piston or something like that.
A person familiar with the inside of that trans model should be able to see the culprit on teardown. But maybe not.
Check your trans harness for shorting wire to wire, and wire to ground. Wiggle it all around good while checking.
Point being.... I wouldn't concern myself too much with the trans rebuild materials and process, nor the programming. I'd be looking at something wrong with that truck/transmission specifically. Warped valve bore.... chaffed wires.... cross-talking wires.... sh*t like that. The general trans build and programming scheme work. Your specific truck/trans has a specific problem.
Ur referring to fire punk right?
Sent from my Milestone X2 using Tapatalk 2
Im sure he is referring to Lavon that is going to change some things in his trans, yes.
I asked fire punk for a trans quote on a 5r 110 n got the email n qoute from rcd
Sent from my Milestone X2 using Tapatalk 2