Midwest pipe install question

[andrewtac]

On what I think is the CAC pipe there are two bungs. What goes in there, is it a factory sensor? If not what do I need to plug them so I can install tomorrow? I polished them today and am done messing with it.

 

[sootie]

Your stock cold side pipe has a sensor in it-i believe iat. Can't say what the other is.

 

[andrewtac]

There were two plugs with the hardware. The sensor in the CAC pipe I took off was a push in with a set screw. Is there a screw in temp sensor that will plug into the harness?

 

[RNally]

You will just use the plugs in this case. The sensor from the plastic CAC tube will just be removed and plugged into the factory connector, not hooked into a pipe. Unless you have some aftermarket temp sensor/nozzle you won't need the 2 additional bungs, unless you have something of the sort.

 

[andrewtac]

Polished the pipes, need to polish the intake too.

 

[bigrpowr]

Polished the pipes, need to polish the intake too.

looks great ! intake will be much easier than the stainless !

 

[HeavyAssault]

I used one for my BOOST PSI sensor. I guess they can be used for anything that is NPT.