Smokyred
New member
Hey guys, I went out to fire up my 6.4 the other day to take it to work. It had been sitting for a few weeks and the batteries were low. It cranked over a little slow but fired up fine. When I was on my way home from work I noticed the check engine light come on.
I hooked up AE on my laptop and the only code that is coming up is P0607-Control Module Performance. I can't really find anything on this code at all. If I clear it, it will usually reset on the second or third drive cycle.
I'm wondering if I can just return it to stock then load up a tune again, or if I permanently corrupted the TCM, I'm thinking that is what the code is for.
Other than the code being active, the truck runs and shifts just fine the same as before.
Thanks,
Dave
I hooked up AE on my laptop and the only code that is coming up is P0607-Control Module Performance. I can't really find anything on this code at all. If I clear it, it will usually reset on the second or third drive cycle.
I'm wondering if I can just return it to stock then load up a tune again, or if I permanently corrupted the TCM, I'm thinking that is what the code is for.
Other than the code being active, the truck runs and shifts just fine the same as before.
Thanks,
Dave