Problem??

[SaltySteve]

Hey guys, I was running down the road and got a trouble light with a pic of a wrench..She started running rough after . I restarted the truck and running fine.. What was she trying to tell me?

Steve...

 

[Addicted4]

Hook it to a scanner to pull the codes

 

[Sterling6.7]

Did it make any beeps from the dash before shutdown? Did you count them?

 

[SaltySteve]

I don't recall any beeps, if it made any it was only 1 or 2. Just a gold square with a wrench in it and wording that said basically see your owners manual. It immediately started running rough, like only on 6 cyls or something like that. It didn't seem to slow me down though, I was in a 45 zone and was able to do that at least. Once I got into a parking lot I restarted it and everything was normal. I am getting a scanner tomorrow so I will see if there any traces of the code it should have created.

 

[Sterling6.7]

Ok. Just making sure you were paying attention. Need to read the codes, if there are any left. Were you pushing it hard?

 

[SaltySteve]

Not at all. I think my grandma would probably drive it harder than I do.
It's my only vehicle and I baby it.

 

[SaltySteve]

According to my new scanner, there are no active codes. I guess it was just a fluke.

 

[PDT1081]

According to my new scanner, there are no active codes. I guess it was just a fluke.

What scanner?