RCD cp3 kit problems

[3736.4]

Installed my rcd cp3 kit on the truck and currently getting 10k rail pressure at idle with the cp3 unplugged and this is how it's supposed to be ran from what i have herd but getting wicked fuel knock replaced k16 and harness and fuel rail pressure sensor still doing the same thing i am running ********** tuning with 100% over injectors with a elite bowl dlete tested all connections everything is in spec honestly lost right now


Sent from my iPhone using Tapatalk

 

[sootie]

Ditch it and get a dual K16 setup. The cp3's are hard to tune and all the ones i have been around have been impossible to control rail pressure at idle. Plus they sound horrific and you are limited to whos tunes you can run.

 

[3736.4]

Ditch it and get a dual K16 setup. The cp3's are hard to tune and all the ones i have been around have been impossible to control rail pressure at idle. Plus they sound horrific and you are limited to whos tunes you can run.

Don't really wanna ditch it hopefully someone from rcd chimes in


Sent from my iPhone using Tapatalk

 

[sootie]

Don't really wanna ditch it hopefully someone from rcd chimes in


Sent from my iPhone using Tapatalk

Good luck...

 

[6.4 Stroker]

Best bet might be to get ahold of Haller’s Repair out of Cheyenne WYO.
I know Mike has tuned a few CP3 kits via EGR wiring on 6.4s

 

[White_monster]

He finally listened and got a new tune and it works now.

 

[6.4 Stroker]

Awesome!

 

[3736.4]

Is there a way to test the pcv vcv on the k16 she was new truck starts idles fine but when getting on the throttle she has a lil back fire and the fuel pressure fluctuates


Sent from my iPhone using Tapatalk