Dirtclod
New member
Ok I've been dealing wirh this issue for quite a while now. The rear end was acting as if I had a bent rim. Like a wobble. Changed tires,rims,rotors,pads,new caliper,new tires. All the universals I n the drive shaft have been changed,even in the front drive shat from the transfer case. The carrier bearing twice. All within the past 3 years. Now the rear I joint is bad again and the one before the carrier bearing. I've put it up on jackstands and the passenger side rear tire has an up and down motion,not a side to side. There's no play if grab the wheel try pushing top to bottom or side to side. There is a lot of movement in driveshaft but I wouldn't think it would make one wheel move that way and not the othe other. I removed the wheel and caliper and removed the bolts from the hub to pull the axle. Rear end grease started coming out. Now if it's like the front there shouldn't be any grease coming out there or should it? Also how can you tell if the bearing is bad in the hub or at the axle?