S3R coolant routing

[Ilike6.0s]

I was lucky enough to snag an original S3R the other day and had some questions. I tried searching on here but didn't have any luck. Does anyone have a write up and/or parts list of mods needed for the cooling system reroute? What confuses me is where the intake and front cover meet at the donut gasket, the coolant port is blocked off in the S3R? Is this where the freeze plug goes?

 

[6.0 Tech]

Knock a freeze plug in the front cover, put some silicone around the outer edge of it. Then run a hose from the oil cooler outlet around the turbo pedestal/hpop area, and use a y or t into the heater hose going back to the hose under the degas

 

[BrewTown]

What 6.0 said exactly. I believe I actually used a Y or T meant for Pex when I did mine. I also wrapped the hose so it wouldn't get melted or chaffed.

 

[FXR99]

What's a S3R ?

 

[6.0 Tech]

Old odawg intake manifold that’s no longer built due to lack of emissions compliance