CallMeColt
New member
- Joined
- Mar 20, 2014
- Messages
- 151
- Reaction score
- 0
Going to sounds real dumb, but where should the probe be installed?
I had a local diesel tuning shop do it & I think they put it on the wrong place... they tapped in where the 90 deg bend is next the the transmission.... I would have thought it was supposed to go as close to the turbo as possible?
I did some searching on here & on Google... I couldn't find a picture for the 6.7L Powerstroke. Earlier models were tapped in right at the manifold (6.0L).
With the accelerator to the floor for 8 seconds & my EGT temperature barley broke 700 deg..... after I had been driving for a while too.
Shame on me for not doing a little research on the subject before having the work done. Should have just done it myself.... I tend to be way over the top particular on stuff like this. I don't even like it facing down because I'd be worried a branch or something could get caught & rip it out. I drive off road a lot.
I attached the picture. Sorry for bad lighting. The flanges bolted together on the top of the picture are to where the *** system would start.
Thanks for any input.
I had a local diesel tuning shop do it & I think they put it on the wrong place... they tapped in where the 90 deg bend is next the the transmission.... I would have thought it was supposed to go as close to the turbo as possible?
I did some searching on here & on Google... I couldn't find a picture for the 6.7L Powerstroke. Earlier models were tapped in right at the manifold (6.0L).
With the accelerator to the floor for 8 seconds & my EGT temperature barley broke 700 deg..... after I had been driving for a while too.
Shame on me for not doing a little research on the subject before having the work done. Should have just done it myself.... I tend to be way over the top particular on stuff like this. I don't even like it facing down because I'd be worried a branch or something could get caught & rip it out. I drive off road a lot.
I attached the picture. Sorry for bad lighting. The flanges bolted together on the top of the picture are to where the *** system would start.
Thanks for any input.