Recent content by bigcountrysg
-
Michigan GTG Sept 2012
Well the first two weeks of Nov. I will be at deer camp.- bigcountrysg
- Post #32
- Forum: Central US
-
Michigan GTG Sept 2012
I have class on the 29th unless it get's cancelled again- bigcountrysg
- Post #29
- Forum: Central US
-
Fuel Line Repair
I must be the only person that feels a tubing bender is a must in tool box. Push lock hose, hmmm not at my two local napa stores. And actually no you do not need a tubing bender any good solid round surface can work for a tubing bender.- bigcountrysg
- Post #5
- Forum: 7.3 Tech
-
Fuel Line Repair
Because you have to order the sleeves. Everything I used is easily obtained with no ordering from your local parts store. Plus the parker sleeves are not cheap they average 4 dollars a piece. Plus they wear out and start leaking. Flared fittings can be loosened and tightened over and over and...- bigcountrysg
- Post #3
- Forum: 7.3 Tech
-
Fuel Line Repair
Ok so you got a leak at your fuel filter housing. The rubber o-ring that is on it is destroyed and you are leaking fuel. You can do a couple things. 1. New fuel line from Ford for 150 dollars. 2. Try and find Parker 60vlv-4 rubber sleeve sleeve good for 400 psi 3. Go to the auto parts...- bigcountrysg
- Thread
- Replies: 13
- Forum: 7.3 Tech
-
Michigan members post up!!
Willis Mi about 10 minutes from Milan Dragway- bigcountrysg
- Post #61
- Forum: Central US
-
Question on front ends
I think the OP is asking about the body parts only not the actual front axle. I am sure you could make the front end of a 2012 work on an older truck. Just might take a bit of modifications to both the front body parts and the older body.- bigcountrysg
- Post #7
- Forum: 6.7 Tech
-
How do I know my hpop is enough for my injectors
Well from my experince with a stock 17* hpop. It didn't work out to well for me. You can read one of my previous threads. Not saying the HPOP caused my problem but it is suspected. http://powerstrokearmy.com/forums/showthread.php?t=1389- bigcountrysg
- Post #17
- Forum: 94-97 Aftermarket
-
Keyless Entry
It is not the remotes, they have been tested are sending signal. The vehicle goes into program mode. But will not respond to the remotes. Dealer is also confused because the truck goes into program mode, but does not respond to the remotes.- bigcountrysg
- Post #14
- Forum: 7.3 Tech
-
Keyless Entry
I have even tried to reprogram one of the extra ones I have for my f-150 still nothing.- bigcountrysg
- Post #12
- Forum: 7.3 Tech
-
Can This Be Done....
If you do you will need the bedsides from a dually- bigcountrysg
- Post #3
- Forum: Suspension, Drive Train, and Tires
-
Paddles for the sand dunes
I suggest getting Super Swamper Boggers. For one if you run paddles you would be swaping them everytime you went and left the dunes. To include going to the camp ground or where you are staying while there.- bigcountrysg
- Post #26
- Forum: 6.4 Aftermarket
-
Keyless Entry
Everything worked just fine til the batteries in the truck went dead a while back. Now that I have the engine running good and the truck back on the road. I am trying to figure out this problem.- bigcountrysg
- Post #9
- Forum: 7.3 Tech
-
Keyless Entry
The one in my owners manual. It says to turn the key on 8 times or so. Then the doors unlock, then you are suppose to hold down the lock button on the remote. But at that point the system does not respond to the remote.- bigcountrysg
- Post #6
- Forum: 7.3 Tech
-
Keyless Entry
Boy people don't listen. I put new batteries in the remote already. They will not program. I have been following the manual. Guess I will go to the dealer.- bigcountrysg
- Post #4
- Forum: 7.3 Tech
