Hoods

LMPirate · Jan 28, 2016

Biggpigg4x4 said:
best I could do for now. Im sure 4everboosted will give you a better idea shortly

Damn that looks good, I think I'm going to go with a cowl just have to decide if I'm going to order it painted or have a body shop do it

4EverBoosted1 · Jan 28, 2016

Don't waste your money having cervini paint it... I did that and it took forever to ship and then UPS scratched the **** out of the hood while shipping. I'm just now getting it picked up from being fixed

Biggpigg4x4 · Jan 29, 2016

4EverBoosted1 said:
Don't waste your money having cervini paint it... I did that and it took forever to ship and then UPS scratched the **** out of the hood while shipping. I'm just now getting it picked up from being fixed

Dang. I was on the fence about ordering painted or not. I ended up ordering it not painted. When it showed up the driver side corner above the fender badges was cracked and missing a good 3 inches of hood. I didn't accept package. Talked to cervani next day and they said one will ship out today. Well, long story short, it took over a month after that day to get the hood to my house. That's about the only complaint is got. Other than that, I love everything about it.

I'd recommened not painted. Cause I watch the body work get done and there was a few low spots my guy spent some time on. Never know if cervani just paints them as is or checks everything. I assume they do but you never know.

4EverBoosted1 · Jan 31, 2016

Got my hood put on Friday. Love the look of it, but unfortunately I still had to notch a hole on the bottom shell so my inter cooler would fit. Other than that it does have a ton of clearance for all my piping

Notneb · Jan 31, 2016

4EverBoosted1 said:
Got my hood put on Friday. Love the look of it, but unfortunately I still had to notch a hole on the bottom shell so my inter cooler would fit. Other than that it does have a ton of clearance for all my piping

But no cutting to the outer shell? What intercooler?

4EverBoosted1 · Jan 31, 2016

Notneb said:
But no cutting to the outer shell? What intercooler?

No, the cervini is a double layer fiberglass hood. I gut cut a small square on the bottom side of the hood to clear my FrozenBoost intercooler. This is what my engine bay looks like

Sent from my iPhone using Tapatalk

dsmracing1 · Jan 31, 2016

4EverBoosted1 said:
No, the cervini is a double layer fiberglass hood. I gut cut a small square on the bottom side of the hood to clear my FrozenBoost intercooler. This is what my engine bay looks like

Sent from my iPhone using Tapatalk

That is a sexy engine bay!