Just picked this up for $250 just minssing the core support and grill etc. The transmission is toast in it so im thinking im gonna put the 7.3 out of the 97 in my sig in it. Should be pretty much bolt in minus getting a 2wd trans the truck in my sig is toast body wise and has been sitting for a...
Well ive found out going through some old manuals that the tailshafts on these trucks were machined with the drive gear in them so other than swapping a output shaft im gonna need a new trans or swap to the psom digital setup off a newer truck does anyone have info about this i have 2 parts...
Ive got an 89 bricknose with the e40d its 2wd and setup with a speedometer cable. The vss and and cable are located in the tailhousing of the trans. The issue started with no speedometer on the dash and the trans shifting like crap. so i pulled the cable from the trans spun it to see if the...
Im having issues starting the truck doesnt matter hot or cold. You try to start it and it wants to start but wont unless you are in the throttle, and once it does start it romps really bad unless you bring the throttle up just over idle for a little bit then it will quit romping. I mentioned my...
My truck has been down for roughly 4 weeks while i did my zf6 swap. Got the truck back on the road tuesday and my brakes went to crap. The pedal goes clear to the floor where before it was excellent the only part of the brake system i touched was unbolting the booster to swap pedals. I have...
Posting for my cousin he has an 05 eclb f250 6.0 studded ******d not been tuned new ford gaskets were installed with the studs has a bradford built flatbed with gooseneck and standard hitch asking 18k obo or partial trade has 118k miles call 765-318-8385
Well i got it bled finally. unhooked the line from the slave vacuum bled the master and filled the slave with fluid before installing the line. all is good other than a severely out of balance driveshaft off to the shop to get a one piece made.