Search results

Just picked this up for $250 just minssing the core support and grill etc. The transmission is toast in it so im thinking im gonna put the 7.3 out of the 97 in my sig in it. Should be pretty much bolt in minus getting a 2wd trans the truck in my sig is toast body wise and has been sitting for a...

Well ive found out going through some old manuals that the tailshafts on these trucks were machined with the drive gear in them so other than swapping a output shaft im gonna need a new trans or swap to the psom digital setup off a newer truck does anyone have info about this i have 2 parts...

Ive got an 89 bricknose with the e40d its 2wd and setup with a speedometer cable. The vss and and cable are located in the tailhousing of the trans. The issue started with no speedometer on the dash and the trans shifting like crap. so i pulled the cable from the trans spun it to see if the...

Ill try to locate a good scan tool to check the icp but ill check the hpop res in the morning if its empty i guess i probably have a cracked cover

Bump

Im having issues starting the truck doesnt matter hot or cold. You try to start it and it wants to start but wont unless you are in the throttle, and once it does start it romps really bad unless you bring the throttle up just over idle for a little bit then it will quit romping. I mentioned my...

Whats your plans for the stocker when you get the winch bumper on permanently i need a stock one mines seen better days

Yeah its all hooked up

My truck has been down for roughly 4 weeks while i did my zf6 swap. Got the truck back on the road tuesday and my brakes went to crap. The pedal goes clear to the floor where before it was excellent the only part of the brake system i touched was unbolting the booster to swap pedals. I have...

Not 100% sure but i believe its an auto call the number in the op he should be available anytime tomorrow

Posting for my cousin he has an 05 eclb f250 6.0 studded ******d not been tuned new ford gaskets were installed with the studs has a bradford built flatbed with gooseneck and standard hitch asking 18k obo or partial trade has 118k miles call 765-318-8385

I finally found one at pic a part for 15 bucks

Nope a zf6 tcase is required different spline count and spline diameter

Well i got it bled finally. unhooked the line from the slave vacuum bled the master and filled the slave with fluid before installing the line. all is good other than a severely out of balance driveshaft off to the shop to get a one piece made.

Might try that it'll be the weekend before i can attack it again

As for the prebled kit like mentioned above im putting this in my obs i cant yse the kit because i have to use the obs master cyl with the sd slave cyl

Yes the stand verticle press slave piston down hold for a few and slowly release been at that all weekend

Just finishing my zf6 swap in my obs. im having a hell of a time getting the clutch bled with no bleeder. Anyone have any tips or tricks to bleed it? ive tried the pump the slave trick for the past 2 days to no avail Its a new master cylinder and a new slave and a new hydraulic line. Does anyone...

Got my hands on a solid front from a 99. Im wanting to use obs knuckles to retain 8x6.5 lug pattern and my dually hubs. Will obs knuckles fit on a sd axle ive searched and found yes and no anyone done it?

Need the clutch pedal assembly for a 92-97 let me know if you have one need it asap