Search results

I have my engine on a stand because I am swapping it into a gasser truck. I checked the injector ohm readings at the plugs to see what they were reading and I get 3.5 across the board. I have read that under 5 is good, I want to do the bitterroot rebuild and 160cc pistons while the engine is...

I have searched up and down on the internet for a straightforward way to build a wiring harness. I wanted one with an oil pressure safety switch and a way to run the pump on a timer so if you keep the key on and don’t start the truck that the pump quits without oil pressure. And also if a fuel...

Does anyone know if the axles on a 2005 5.4 f 250 are the same as a 2005 6.0 f-250? I. Want to do another swap on an obs and have an opportunity to buy a gasser cheap Sent from my iPhone using Tapatalk

I have the option to buy an aurora 3000 off of my buddies 6.0 (needs to have new bearings installed) pretty cheap. I am wondering if it is worth my time to purchase and try to fit it in my obs ? Couldn't find anyone that had done it on the net, maybe it's a huge job or something. Thanks for...

My 96 7.3 will puff lots of white smoke while cranking when it is cold and is quite hard to start. It will crank and crank and crank then fire and romp once or twice then die again, then crank and crank and crank with the white smoke. I have an e fuel system on it and it will fire right up...

Hi I did the 06 axle swapon my 96 and was wondering if maybe anyone that did this swap and used the 2-1435 neapco u joint conversion joint could share their experience with it. How it has been holding up etc. thanks Sent from my iPhone using Tapatalk

On the front yolk off of t-case how many inches of slip do you need to make it strong enough? I have it measured out that I would have 2.5 inches for it to slip in before it bottoms and it would be slid on the shaft 2.75" . Would this make it strong enough and allow for enough movement when the...

Hi I am going from auto 2wd to zf5 4x4 conversion. Have a couple questions, first is about the crossmember for the Trans. I have the factory auto crossmember that seems to want to push the Trans up to high and a crossmember out of an 89 truck that doesn't match up to any holes on the drivers...

I put together a efuel setup in the valley and replaced the factory seals on the feed lines. Before I throw the turbo and up pipes back on I wanted to pressure test the system up and make sure it has no leaks. Basically just the stuff I changed in the valley, my question is if I hook into the...

I bought a 1996 ext can short box f-250 2wd with a blown transmission for a pretty reasonable deal. I am converting this truck over to a 4x4, 5spd with 06 f-350 axles and a 6.0 pump/e-fuel/tightwad mod setup on it. Everything I am doing is as budget minded and diy as possible. I have...