Freightshaker
New member
Hey thank you. I got one in a hurry but I might still check out a Stancor for the spare parts shelf. The cost on the factory solenoid is a joke... It's Just a solenoid/contactor/relay
01-mpg seem low/trouble with cold start
- Thread starter Freightshaker
- Start date
Hey thank you. I got one in a hurry but I might still check out a Stancor for the spare parts shelf. The cost on the factory solenoid is a joke... It's Just a solenoid/contactor/relay
POWER-STRUCK
New member
i agree that they are over priced, alliant makes one about 20 bucks less and the napa units seem to make a humming noise and fail prematurely
Freightshaker
New member
Oh yay!!! That's what I got. Haha oh well I keep a screwdriver handy
whyyyy I remember when a ford 4 prong relay cost a guy $9,
POWER-STRUCK
New member
you can use a cheap ss598t relay but have to place 2 small wires on 1 post and other small post un used
Freightshaker
New member
Finally got a chance to test my EBP transducer. According to my test it is junk. Makes me feel better buying a new one. (if I even did it right haha)
I brought home a signal generator from work. It can produce the necessary 5VDC. Anything that produces a steady 5VDC would work I even had a model train transformer that was.
I cut some spade terminals to fit in the EBP sensor.
Used a few fittings to hook up the transducer to pressure.
(I used the link provided by powerstruck and a wiring schematic from a previous post to hook up the rig.)
Then I hooked up the pressure source (nitrogen for me)
Feeding it pressure from 0-40 I was getting no response off of the signal post reading it with my meter.
I brought home a signal generator from work. It can produce the necessary 5VDC. Anything that produces a steady 5VDC would work I even had a model train transformer that was.
I cut some spade terminals to fit in the EBP sensor.
Used a few fittings to hook up the transducer to pressure.
(I used the link provided by powerstruck and a wiring schematic from a previous post to hook up the rig.)
Then I hooked up the pressure source (nitrogen for me)
Feeding it pressure from 0-40 I was getting no response off of the signal post reading it with my meter.
Freightshaker
New member
Strangely enough when I hooked it up like that it worked.
Here were the values I recorded in that setup:
0psig-1.049VDC
5psig-1.590VDC
10psig-2.113VDC
15psig-2.699VDC
20psig-3.209VDC
25psig-3.780VDC
30psig-4.320VDC
35psig-4.820VDC
