4EverBoosted1 Elite Built 6.7 Thread

[Powerstroke Cowboy]

That's a good welder. I have been tossing around pickup up the Dynasty 200 Series. Just for the thicker metal.

Very nice welds though! Look really good! Welds can make or break how pipes look.

 

[Morgan@Midwest Diesel & Auto]

What's the chance of snagging one of those t6 flanges? Would look really nice on the race truck.....

 

[MorganY]

What's the chance of snagging one of those t6 flanges? Would look really nice on the race truck.....

Sure. PM sent

Sent from my SAMSUNG-SGH-I337 using Tapatalk

 

[dstryr]

Less sleeping more wrenching!!!!

 

[MorganY]

Sent from my SAMSUNG-SGH-I337 using Tapatalk

 

[O2ShootTheJ]

mmm donuts

 

[dstryr]

Need to polish that up man!. What a ****ty turned finish lol

 

[sootie]

is that for the turbo cover or what is it? (pardon the ignorance)

 

[4EverBoosted1]

is that for the turbo cover or what is it? (pardon the ignorance)

It is somewhat a joke. Morgan found it at my house and won't put it down lol

 

[Powerstroked162]

is that for the turbo cover or what is it? (pardon the ignorance)

It's a velocity stack. Pretty common to see on forced induction cars running turbos.

 

[Erikclaw]

It is somewhat a joke. Morgan found it at my house and won't put it down lol

AAAhhhhh mam is that your dads ass gasket for the toilet?
:lookaround:

 

[97stoker350]

Does it help that much

 

[4EverBoosted1]

AAAhhhhh mam is that your dads ass gasket for the toilet?
:lookaround:

Can't risk a leak in that seal.

 

[MorganY]

Does it help that much

In theory, less turbulence around the induction area. Especially if pulling through a headlight.

 

[Super08Duty]

Get your red bulls ready...I'm on the way

 

[MorganY]

Get your red bulls ready...I'm on the way

For real? Shots? Lol.

Downpipe is done. MIG'd the downpipe for obvious reasons. Not officially set yet, still tacked in. Waiting to get it up on the lift to do so.

Let me know what you guys think.

Next up is moving the mess of wires.
Open to suggestions...so far plan is up behind the fender along the outer support...

Sent from my SAMSUNG-SGH-I337 using Tapatalk

 

[Powerstroked162]

Can you bring the 90* off the turbine outlet, closer to the turbine outlet? May help with heat issues.

 

[Powerstroke Cowboy]

Can you bring the 90* off the turbine outlet, closer to the turbine outlet? May help with heat issues.

:whs: I agree. Looks like you could get it about a 1.5 to 2 inches closer.

Other then that I think it looks top notch!!

 

[MorganY]

Can you bring the 90* off the turbine outlet, closer to the turbine outlet? May help with heat issues.

Yes I can. The wires have plenty of slack and are just resting on it for photos now until we can move them. They are ~3.5" away from the DP after being pulled back.

(Will be wrapped too)

I should be able to pull the 90 in another inch or so

Sent from my SAMSUNG-SGH-I337 using Tapatalk

 

[Powerstroked162]

No doubt you should be good. A little tighter might make your life easier in the end. As always though, you know my thoughts on your work