4r100 in 6.0

Powerstroked162 · Oct 1, 2013

Greg@MPD said:
The casing of the modular 4R is tapped on the bottom two holes, so you need to drill the back plate of the 6.0/6.4 and put the bolts in the other way.

That's much different then drilling new holes in the case. Thanks for clarifying

.

stroker57 · Oct 1, 2013

Powerstroked162 said:
That's much different then drilling new holes in the case. Thanks for clarifying

.

I drilled the two holes on the trans Greg is talkin about instead of the motor plate was much easier. Sorry for the misunderstanding that you thought I meant new holes I did mean the hole that were already there but like I said I couldn't remember right though there was indents instead of holes sorry

pipeliner · Oct 1, 2013

stroker57 said:
No need to change the flex plate stock one works just fine. Who's building your 4r ? As far as anything you missed you have to drill the bottom holes out on the trans. You don't use the the top holes at all

bts will be building it.

pipeliner · Oct 1, 2013

stroker57 said:
I'll have to look again on how it wired up I had Craig help me do mine. But if I recall you only use 3 wires out of the harness and the rest a just extra

any closer on the wireing.