95 f350 rear end rebuild...

[MidwestYak]

so i want to regear the truck to 410s.... does anyone have a link to a thread or video that may have specs for torquing things, down back lash, and how to set/change/adjust the gear meshing... ive watched every video i can but noone actually has specs... any help would be nice, tia!!

 

[Peroni]

I used this article on Pirate 4x4 to rebuild my 97 rear axle Gear Setup

And this link has the torque specs for the Ford axle Ford Axle

 

[MidwestYak]

Ok cool thanks bud!!

 

[m_j]

buy crush sleeve eliminator from yukon as well as their master install kit. it will make the install far easier.
the eliminator will be for a 9" but all you have to do to make it fit the 10.25 is file a little bit to clear the radius on the pinion of the 10.25

you will need an inch lb dial type or beam type torque wrench to set pinion bearing preload. the nice dial type are about $400, I borrowed one.


the yukon master kit comes with a nice shim holder for the carrier shims

 

[79jasper]

May even get extra various shims.

Sent from my SAMSUNG-SM-G935A using Tapatalk

 

[bens]

A case spreader is nice too, i got mine for around $150 on ebay. Also setup bearings are a must imo

 

[m_j]

setup bearing are useless on a sterling. the adjustments are made out side of the carrier bearing so you never remove them.
I bought a set for my d60 but didnt find them all that handy.

 

[bens]

Thanks for correcting me Mj, disregard my post.

 

[MidwestYak]

dang sorry it took me so long to get back guys. i appreciate the info!