Most power and fastest times with a VGT......

imelmo · May 18, 2014

stonepusher said:
Well finally got it to the track for some good runs, ran a best of [email protected] on fuel and [email protected] on one stage of nitrous. Not sure quite what happened on the ET but i was running a heads up race with a cummins and he ran a 10.80@124, but I won the race, first to the finish line. Calculator puts it 914hp to the wheels, not bad for a Vgt. I think this turbo is about tapped on air, time to grow up and run with the big boys.

You must've destroyed him on the tree.

.

6 L chevy eater · May 18, 2014

imelmo said:
You must've destroyed him on the tree.

.

Yes

stonepusher · May 18, 2014

imelmo said:
You must've destroyed him on the tree.

.

6 L chevy eater said:
Yes

Yea I did, hoping so there is some vid of it so hopefully I can get it put up later.

swinky · May 18, 2014

What studs did you go with this time?

Sent from my HTC One using Tapatalk

william_ace · May 18, 2014

He hasn't done a built motor yet. The one in there now is a take out from a truck at the shop that was getting a cummins swap. Standard ARP studs.

swinky · May 18, 2014

william_ace said:
He hasn't done a built motor yet. The one in there now is a take out from a truck at the shop that was getting a cummins swap. Standard ARP studs.

That's right I've already asked him lol I think it has h-11s though.

Sent from my HTC One using Tapatalk

HobbyStock62 · May 18, 2014

wait, not a built motor as in stock bottom end? no rods at 914hp!?

swinky · May 18, 2014

Correct

Sent from my HTC One using Tapatalk

KCTurbos · May 18, 2014

I was talking to Chris about mikes truck and I wonder how much the super low pulse width and not too much timing is helping out with the head gaskets and bottom end. I could not believe how low they were running.

Very imprrssive.

swinky · May 18, 2014

Probably just his nitrous tune.

Sent from my HTC One using Tapatalk

KCTurbos · May 18, 2014

swinky said:
Probably just his nitrous tune.

Sent from my HTC One using Tapatalk

I was only talking to Chris about his fuel only tune. I recommend Chris (TSD) for tuning most my turbos. He always does a great job.

With 150% nozzles you don't need much PW

stonepusher · May 19, 2014

KCTurbos said:
I was only talking to Chris about his fuel only tune. I recommend Chris (TSD) for tuning most my turbos. He always does a great job.

With 150% nozzles you don't need much PW

Exactly..... I believe he has this tune at 1.75ms...... I'm just out of turbo and pump now :-/