Recent content by baddkarmaracing

Let me research some and I will get back to you

how about a leather wrapped steering wheel (black) for my 2011 f250 with out steering wheel controls? its an xlt and has the regular wheel but its bent and I want to replace it with one that is leather wrapped. only buttons on the wheel are for the cruise and the driver info center or what ever...

4.30 sounds like a lot of gear for 35's I would say 4.11

I would have them powder coated, should cost around $75-$100 a wheel.

Well I guess I get to run the 17's I want then!

Does this look right? Never done airbags before and I want to make sure I have this setup properly when I do it. The reason for the regulators is the compressors shut off at 200psi which is double what the bags max pressure, and most air tools are rated around 90psi if I remember right. Also...

weird I have never seen a stock 6.7 superduty with 17" wheels and in a suspension thread a few weeks ago it was said that most will not fit.

really? I was looking at some base model trucks last week and they all had 18's

I know the general rule is 17" wheels don't fit, but there are some that do. is there a list anywhere that shows what wheels are known to fit?

i thought brake fluid was flammable so no I haven't tried heat Just checked a bottle of it. Doesn't say any Anything about being flammable

No rot, I honestly think some one just tightened them down way too much.

I have a bds brake line that is split on my truck, normally no big deal but its stuck on both ends (frame and axle). I messed up the nut on the axle side which is no big deal, the whole hard line is only $30 from the dealer. but the frame side is a different story, its 2 lines together and a...

you have any mounts besides the one edge sells? I have the older CTS

If you can find that out I might be interested in shipping my truck up there...

What do they want to charge in labor???