If one stick is good, several must be better!
Check out the lightning shifters from Kilduff Machine for manual valve bodies. One stick for each shift. May get confusing on the street.
When I looked into getting a mill many of the ads said they could load it on a trailer for you. Would you be able to off load it? I bet so.
Don't forget that many of the Bridgeport style knee mills have 3 phase motors. Just factor that into your budget when shopping.
I came to the...
This sounds like the ultimate fuel bowl "da lete", but I always wondered if doing this was too much for the HPFP's volume control valve.
How many miles do you have on this setup SEABEE & what is downstream of the Y opposite of the HPFP?
Thanks
Smokinstroker, Can you post a pic from front to back even with one side of the truck to see the offset?
What would be about the minimum amount of lift a 08 250 would require to fit these? I am leveled now & not wanting much higher.
I'd like to know why Lavon's truck is not eligible yet there are a couple very similar Cummins in the group.
DP definitely going to crap....they listed the 6.4 cummins as being debored from 6.7. The typical way to build a 6.4 cummins is to destroke the 6.7 with a 5.9 crank.
Is the questionable reliability of the AD's isolated to certain models? I have one on my Cummins that has been holding strong for 7 years. Maybe I was just lucky.
I do agree with the recommendations to go with fuelab or aeromotive. Guess I will be doing one sooner than later since I have a...
I have found plenty of useful info here so I figure its time to join in and contribute when I can.
Short Story:
I'm a Cummins fan happily trapped in a slightly modified 6.4 that continues to exceed my expectations.
Long Story:
Introduced to diesels from an accessory shop I worked in that...