So it begins

isootmypants · May 22, 2015

Dmstrucks02 said:
Did you put a valve before the filters? How's filter changes

Needle nose vice grips

Dmstrucks02 · May 22, 2015

isootmypants said:
Needle nose vice grips

LOL I got a valve but it has a tiny orifice compared to the line, so I guess I'm just going to do a brass ball valve at the sump..

isootmypants · May 22, 2015

Dmstrucks02 said:
LOL I got a valve but it has a tiny orifice compared to the line, so I guess I'm just going to do a brass ball valve at the sump..

Haha I'm kidding. I hadn't changed the fuel filters yet. I don't think it's drain too much

isootmypants · May 22, 2015

Finished routing to sump.

http://i18.photobucket.com/albums/b145/wtbz400/Mobile Uploads/image_13.jpg

Ordered 2 -12AN 90* to barbs for valve cover breathers, and a -8AN to -6AN reducer to feed back of heads. Ordering Gen3 next week. Putting stock 17* hpop I have, then installing Gen3, make up a nice mount for regulator. Finish up top of motor fuel system. Already installed all black fuel fittings on motor. Need to pick up some reflective heat wrap for fuel lines on back of head, then make nice oil dipstick holder since it doesn't fit with aluminum valve covers.

02BigD · May 22, 2015

isootmypants said:
Yessir.

So....is it running yet

oke:

Congrats

Dmstrucks02 said:
Did you put a valve before the filters? How's filter changes

Yes at the sump outlet, easy peezy. Also an added theft deterrent.

Dmstrucks02 · May 22, 2015

02BigD said:
So....is it running yet oke:

Congrats

Yes at the sump outlet, easy peezy. Also an added theft deterrent.

Yea I'm going to get a ball valve, I bought a "miny" valve but it's not full flow and the orifice is small compared to the line so I'm not sure if I want to use it