72mm non VGT 300 150 dd setup

[Craig@MFI]

Not always, if its not properly matched to the compressor

Specially not a garret turbine..

 

[faster6.0]

well no one has mix matched up compressors in this scenario, so it's understandable that the garrett spools better, being roller bearing and a smaller turbine vs the BW, that's all I'm sayin' LOL

 

[Craig@MFI]

That's the point a garret doesn't spool better and the data you have for saying it does vs the batmo was the worst example .88ar open housing is Probly the worst spooling turbo in history

Btw that speedo moves pretty slow for 300/150 hybrids and a72..

 

[Craig@MFI]

Lets see a brake stall build up too 20 pounds were you would launch at??

 

[faster6.0]

If the track is open thurs I'll be there sweet cheeks, and no it isn't a bad comparison because I tried the 72 with an open housing as well, and it still spooled tremendously better than the jb s366 billet batmo.... So needless to say ill be buying roller bearing Chargers solely for my vehicles from here on.

And thanks Craig I think it pulls pretty good for a street tune

 

[faster6.0]

There's no difference between the turbine wheel on a 4094VA and 4094R. They both measure out at ~77mm x 68mm for a trim of 78.

Nate I would like to appologize buddy this is in fact correct!

 

[SEABEE08FX4]

Yea Eric, that's the specs on the turbine, damn thing is huge. I ran the 4088R

I have something of similar spec from turbonetics, its a 76 compressor and 68 exducer. Might throw it on for chit's and giggles.