Search results

  1. KPSquared

    s362 vs KC drop in

    I've seen the discussion multiple times on here but the sticks and tunes always vary so it leaves me wondering. I'm going to make the choice soon. My truck is just a driver. Pulls 12k all summer and does the occasional burnout. Planning a turbo and possibly fuel upgrade. Will the s362sxe...
  2. KPSquared

    Another axle swap thread

    I've done some research and I know how easy an 05 axle swap into my 01 is. I have access to a complete set on the frame. However... I also have a line on an 08 set on a frame and I want to run a 4" lift. What's different about 08 and up? If I'm running a lift with new radius arms etc, I'm...
  3. KPSquared

    366 sxe vs Garrett Variants

    It's likely turbo time. 35psi runs have been hard on my stock set up. I keep getting told T4 or nothing from many people I respect in this industry so I figured I'd come here and get a few more opinions. My sig is accurate so based on that... Will I be happy with a KC38 or Diesel Site or...
  4. KPSquared

    Shift points onot Daily and Tow tunes

    I just put a hydra in my '01. Custom tunes from a reputable tuner. I HATE the way it shifts but I'm not sure what to ask him to fix. It drops into OD at 50mph unless you're standing on it. Does the same in the tow tune. Also seems like the TC unlocks almost as soon as I let off the pedal...
  5. KPSquared

    Wastegate not opening

    I put a Turbomaster Actuator on my stock turbo. 160 singles, DP F6, intake/exhaust. It doesn't seem to be opening and I can't figure out why. I push more than 30psi in a blink and I've got the nut backed all the way off. Any ideas? Gauge is somewhat accurate because the CEL comes on...
  6. KPSquared

    Won't run with Scanner plugged in

    2001 bone stock. Runs well. As soon as you plug a scanner in, the truck won't start. Plug it in while it's running and it dies. Tried multiple c scanners and an OBDlink dongle. No codes KOEO Any thoughts?
  7. KPSquared

    Dead Short at Fuel Pump

    Hey guys, Before I start pulling greasy tape and loom off a pile of wires, I'm wondering if there is a common point where a dead short in the wiring to the fuel pump would occur. When I put my multimeter on to check continuity to ground, I have it on both posts of the pump. Of course this...
  8. KPSquared

    Definitive Transfer Case info?

    Trying to figure out what t-cases with what spline counts are behind what trannies in what year of trucks. Links or info very much appreciated. There's a lot of conflicting resources.
  9. KPSquared

    New Compressor wheels vs. e99

    So, aside from the DS vs RR wicked whistling wheel debate, for my very lightly modded rig is the upgrade worth it? Clay has the early 99 wheel on for like $66. Is triple the price worth it for RR's 6/6 wheel or DS's 5/5? I have a little surge with my truck now. '01 with BAHF, 4" exhaust, DP...
  10. KPSquared

    Truck stuck at work. . .no start, no tools. . .yet

    Hey guys, The beast fired up find this morning and I drove to work with no issues. I came out at 2:00 to find the command start hadn't started it and it was just sitting. I jumped in, cycled the glow plugs (it's 5*F here right now, it was plugged in) and it just went CLICK. doesn't seem to...
  11. KPSquared

    Side of the road. . .need advice.

    Hey guys, my dad is out from BC (9 hour drive) and his late 99 7.3 just took a dump. Going down the road, started to lose power, pinged when he would apply throttle, and smoke. Now it won't do much but a super lumpy idle with smoke. Thoughts? I need to get him back on the road. I'm...
  12. KPSquared

    Built 7.3 Kijiji Alberta

    Just saw a built 7.3 on Kijiji in Alberta. I think Edmonton but I'm on my phone and can't find the ad. Looked like a good motor if anyone is looking. Just a heads up.
  13. KPSquared

    2001 Mirror to Mirror Width?

    2001 F350 CCSB SRW 4x4 Hey guys, I'm stuck at work without a tape measure and lots on my brain. . . If any of you have a chance, can someone tell me what the width of my truck is with the tow mirrors not extended? And then maybe the width with them flipped in? Trying to do some planning for...
  14. KPSquared

    Cold Start smoke. . .

    Hey guys, I know this has been discused a lot, but before I tear into things and start hunting, I just need to make sure I'm hunting in the right spot. 2001 7.3 with Full Force stage 1 singles, DP tuned. when I fire it up, it smokes like crazy. Grey, hard on the nose smoke. Unburnt fuel...
  15. KPSquared

    Power Steering Pump swap?

    Hey guys, So, my Dad was coming home the other night and blew a line on his power steering pump. Thinks the pump was weak anyways but running it for a few minutes without fluid has caused it to become non-functional... A reman pump is $97 without the reservoir and $150 with... He wants to...
  16. KPSquared

    6.0 Gods... Please Convince Me!

    Hey guys, So, I'm a die hard 7.3 guy as is the rest of my family. My cousin just found a SMOKIN deal on a 2005 F250 CCSB. Low miles, never any problems. Have the full dealer history. Still under factory warranty. (For another month or so). All I really know about the 6.0 is what I've...
  17. KPSquared

    Why does no one respond to these posts?

    There are lots of posts here with no response from Sunrise... I received no PM or anything... assuming they don't check this forum?
  18. KPSquared

    HPOP lines and quick connect fittings

    Can I get a quote plus shipping to T9A 2E9, Alberta, Canada on both HPOP lines and all 4 fittings for my 2001 F350 7.3?
  19. KPSquared

    Blew an HPOP line...

    So, I hit the throttle to feel my still new-to-me power and she jumped and then died... I hit the key and coasted off the road. Noticed a ton of smoke coming out from under the hood... So I jumped out, opened the hood and saw oil sprayed EVERYWHERE... I can only assume this means I lost an...
  20. KPSquared

    DIY Regulated Return

    Well, I've decided to build my own RR and make it as simple as possible. I don't plan to build a full fuel system, just eliminate the dead head at the rails. I' figure I'd post my progress up here. Haven't decided on hard line or hose/push loks. It depends on what I can get locally. The...

Members online

No members online now.
Top