Little back info. X has been running rough for some time. Not terrible just running rough. My AE wasn't working for a while. I finally sent the module in and they fixed it. So basically I have not run a scanner on the truck since doing the injectors, turbo etc......
Well I finally got around to it today after swapping on the SP1 HPOP.
Got back they typical errors codes for exhaust intake heater etc..
Also glow plug module and a couple glow plugs. But its getting warm now so no big deal there.
Then I got into the troublesome. I will list everything I got including the none issue ones just in case.
General Trouble Codes:
P1690 Wastegate (non-issue)
P1000 ODB Readiness Test Not Completed (non-issue)
P0475 Exhaust (non-issue)
P0541 Intake Heater (non-issue)
P0683 Glow Plug Module Communication Circuit Error (Not thinking related??)
P1316 IDM General Code ***** (I see this I usually think UVC or main wiring harness connection issues)
Cylinder Contribution Test
P0263 Cylinder 1 Circuit Contribution Balance Fault
P0266 Cylinder 2 Circuit Contribution Balance Fault
P0284 Cylinder 8 Circuit Contribution Balance Fault
Buzz Test
(All Injectors could be clearly heard and sounded the same)
P1271 Cylinder #1 High to Low Open
P1274 Cylinder #4 High to Low Open
P1275 Cylinder #5 High to Low Open
Symptoms: Engine runs rough especially at idle.
As part of the HPOP install I also did the following not related to the issue:
Replaced IPR valve with a New Ford manf unit
Replaced ICP Sensor with New Ford manf unit
Has a grey CPS a year old
I have a week long trip I need to take this on that I leave for this weekend.
Well I finally got around to it today after swapping on the SP1 HPOP.
Got back they typical errors codes for exhaust intake heater etc..
Also glow plug module and a couple glow plugs. But its getting warm now so no big deal there.
Then I got into the troublesome. I will list everything I got including the none issue ones just in case.
General Trouble Codes:
P1690 Wastegate (non-issue)
P1000 ODB Readiness Test Not Completed (non-issue)
P0475 Exhaust (non-issue)
P0541 Intake Heater (non-issue)
P0683 Glow Plug Module Communication Circuit Error (Not thinking related??)
P1316 IDM General Code ***** (I see this I usually think UVC or main wiring harness connection issues)
Cylinder Contribution Test
P0263 Cylinder 1 Circuit Contribution Balance Fault
P0266 Cylinder 2 Circuit Contribution Balance Fault
P0284 Cylinder 8 Circuit Contribution Balance Fault
Buzz Test
(All Injectors could be clearly heard and sounded the same)
P1271 Cylinder #1 High to Low Open
P1274 Cylinder #4 High to Low Open
P1275 Cylinder #5 High to Low Open
Symptoms: Engine runs rough especially at idle.
As part of the HPOP install I also did the following not related to the issue:
Replaced IPR valve with a New Ford manf unit
Replaced ICP Sensor with New Ford manf unit
Has a grey CPS a year old
I have a week long trip I need to take this on that I leave for this weekend.
Last edited: