Recent content by WoodBoy

I have one still. I'm pretty sure its Mike's. PM me an address and Ill send it on

I noticed yesterday a chatter noise that seems to be coming from under the hood around the driver's side. I can hear the noise when slightly accelerating. It makes the noise from about 1400rpm till about 1900rpm and i cant hear it anymore since the injector rattle drowns it out above that. It...

I run the pro comp drop mounts on mine with only a 2.5" leveling kit. I think they were also stated for 4"

I'm done with it if someone needs it

Have you checked to make sure you haven't just slung a weight?

I have seen a couple of trac bar bushings gone out to cause this on several trucks. I need to check mine out as a matter of fact. Mine seems to want to try and wobble on me

You have to go into the programmer settings and adjust the transmission belt tension

Clean-15, are those pictures right after install? Any weathertechs I have installed would fit sometimes like that but after they got hot once or twice in the baking heat they would contour well. The heat gun sounds like a good idea if its not warm where you live

"What about the new no limit 5",unless i'm mistaken its supposed to be the best out there right now,it's the newest kid on the block and hasn't been out to long,just something else to consider." - charles henson This was posted on the nation from him when someone was asking about stock vs an...

200lbs in the drivers seat 80% of the time and not in the passenger seat probably doesnt help the issue along with the fuel tank on that side like Eric stated

Have you checked your oil for diesel? Any excessive smoke? Rough idle?

I thought I've seen a picture of a 6.4 with these wheels but I've searched and searched and I'm not sure if it wasn't on here or I'm not typing in the correct thing but I haven't found it. What I'm looking for is a set of the 2011 and up 20" KR wheels on a two tone 6.4. Thanks

Same problem here...

I found the best way to look for leak was to start at the pump and work your way away from it pulling lines and covering with your finger so that if it pulls a vacuum and shuts off=good, and if not then you know the problem is between the last point that checked out and the one that didnt

And the sig...............................................................................