Search results

Can you buy just the bearing for an idler pulley or must the pulley be bought as one?

After a brand new powermax my truck is still pouring white smoke. This is the exhaust side of the old powermax i took off. Notice oil leak At idle. FICM & injectors test good At the end of my rope:morons: Disscuss

Looks like burnt bubbly oil. White smoke caused this. The turbo spins freely by hand, no binding. No shaft play.

Size 11 boots in good shape. Loacted in Pitt, PA

Tested my injectors in class today with the snap-on modis, everything is OK. The white smoke is constant at idle and driving smells like diesel and oil. What else can it be? Coolant level has maintained its level and its not puking. Can a injector test ok but still be bad? Open to...

Up for sale a bulletproof 6.0 egr cooler. This cooler is blocked off NO exhaust gas flows through it. Asking 250 OBO. You pay shipping from 45805

I tore down my truck to do egr and oil coolers. When I was putting everything back together I noticed water dripping from the cold side CAC pipe. So I tasted it and it was coolant. How is coolant finding its way into the pipes?

The pilot bearing or something else in my clutch is making a grinding/vibration. Engine is stock with a mild Innovative tune. What kind of clutch should i get? OEM? or something like a southbend?

Has it been done? Can it be done? would you be able to use the 6.4 fuel system?

I get nasty grinding noises when i left my foot off the gas and at cruising speed, it will not happen when you accelerate. Its pretty hard to explain using words, almost like a gurgling miss is my best description. Its also pretty loud (you can hear it over the radio) I thought it was my...

What did you use to plug the hole in the intake and what size hose is needed to re-route it?

Alright my truck has had some pretty bad cold starts, buck, jerk and tons of white smoke smells like very rich diesel fuel, it will burn your eyes. So I take it to Ford to have an injector test done... It passes every test they try, the service writer tells me he thinks my tune is over fueling...

I have a manual transmission W/O upfitter switches. I hooked up the white with blue strip wire and the purpule with green strip wire to switch and still dos not work. I have read that the mod does and does not work w/ manual trans. Mine is not working. Can anyone shed some light on this? Thanks...

Alright sinister has directions for their egr delete that states you do not have to take the intake off.... what are your thoughts on this http://www.mkmcustoms.com//instructions/instructions.pdf

I am doing a egr delete, what coolant should i put back in and where should i get ? heard something about using CAT coolant because it has no silicates? i also plan on running a coolant filter

Seems like everyone has the auto, anyone have a built motor and have a zf6? if so what are you 1/4 mile times?

Ok, so every time i start my truck it pours white smoke untill warm.... The smoke smells like diesel to me not coolant. coolant level has gone down a little after it puked. Blown egr cooler? will try to get a vid if i can figure out how to put it on here

Replaced cig lighter fuse, still dos nothing when i plugged in my SCT and a matco scanner. What now?

My sct stopped working ,does nothing when plugged in. Its tuned by innovtive and the truck is on street now, what can i do? i like to get it in tow most of the time...

Just installed the blue spring runs great no drive ability issues i can i hear a whistle from it when the fuel pump turns on