Search results

Hello, for those of you who may remember, I have a late model 99 F250 SD 7.3/ZF6 that thanks to the previous owner has numerous wiring harness issues. There have been a few 'fixes' along the way but I'm fed up and would like to do it right. I have been told to get a compatible harness I need a...

Does anyone know where I could find a blue print of floor plan of some type For a 1999.5 superduty with a zf6? My current one is a bit butchered from the previous owner and I am hoping to make a patch of some type so that the shift boot fits how it should instead of with self tapping screws...

Today I was replacing a seized caliper on the rear axle of my 99.5 F250 7.3/zf6 off road and noticed that the rear axle had the driver's side caliper in front of the axle and the passenger's side caliper behind the axle. Is this correct, I've never seen anything like that before. Thanks in...

I have a CompuStar auto start in my 99/02 F250 7.3/Zf6. Sometimes when I enable it so that I can start the truck it goes into alarm mode about 30 seconds after I walk away. So much that I've had the alarm disabled. The shop has tried everything they can think of, anyone have anything similar happen?

So my truck came with a pretty nice audio system. A nice box with an amp and 2 ten inch subs that fit under the seat in the extended cab. This was great until they got stolen out of the truck while it was at a body shop..... So now comes shopping for a replacement. I would just replace the...

My 99.5 7.3 isn't starting right. Only when I can get the starter to higher RPMs after a few tries which normally takes it getting running jumper cables to another running vehicle. I have a hunch glow plug (relay) or fuel filter. I was thinking bad fuel because it started after I put a half...

This may be a dumb question, but I've been reading through and pondering the idea of adding Waste oil to my tank. Just as a supplement to burn it off. What I'm reading is that I'd need run it through centrifuge, to be safe about it and I doubt that it would be worth it. Is this correct? Thank...

I'm laying here in my bed (at work in AK) thinking about my truck (Back home in MN. The last time I was home I noticed a squeaking behind the grill at idle. Due to the changing pitch and similar sounds from the past my first thought was a pulley on the belt. But, honestly my trips home are...

Hi, I have a 1999.5 f250 7.3/ZF6. The top of the shift boot was just self tapped into the cab floor. judging by the large holes on the plastic base of the shift boot and the holes on the top of the transmission, it looked like there was a part that was suppose to come up and meet the bottom...

Does anyone know where I could find a shift boot and a full floor mat for my 99 F250 Extended cab? Thanks, John

My name is John and I have a 99.5 7.3, I bought it with K&N that was dirty with a rusty airbox top. So I replaced it with a 6637 kid from Riff Raff. I like it fine but I'd like something that wouldn't have the filter right up against the fender and would incorporate my filterminder and sensor...

Yesterday after pulling my boat up the ramp in 2nd (whoops), clutch has gradually been feeling softer more often. I'm sure you've heard this before, feels like there's nothing behind it it will engage/disengage every once in-awhile. But not on command. I used the Search feature and originally...